Applications:
Welding of all types of mild (low carbon) steel
Steel structures –trusses, portal frames, tube transmission
Sheet and plate metal structures and containers –plating, storage tanks, hoppers, silos, bins
Fillet jointing of pipes for water, gas and fluid transmission
Site jointing of H/sheet/pipe piles
Light steel frames = grills, ornamental and gate works, furniture
General workshop welding and maintenance
Compatible and suitable for welding steels to: ASTM (eg A36), BS EN 10025 (eg S75, S275 JR), API Std. 5L (eg grade A, B, A25, X42, X46) BS 4360 (eg grade 40, 43) JIS G3106 (eg SS41, SM41)
EXCLUSIVE FOR PHILIPPINE MARKET ONLY
COMPARABLE TO: FUJIWELD F-13
Characteristics:
Very Easy initial arc strike (ignition and cold re-striking properties, for easy tack welding or by point welding
Ultra smooth quiet and stable arc
Low level and odorless fumes
Easy slag removal almost self-peeling in most conditions
Beautiful and finely rippled bead even in fillet welding for nice finishing
Outstanding all position welding performance including vertical down
Can use “touch type” or contact welding –giving ease and comfort to welders
Fine and very few spattering
Suitable for both AC and DC +/- welding source (even on low open circuit voltage 50V)
Notes on Usage:
(1) Pay attention not to exceed the range of proper currents. Welding with excessive current not only lowers X-ray soundness, but also causes increase of spatter, under-cut and insufficient slag covering.
(2) Dry the electrodes at 70-100 degrees C for 30-60 minutes before use. Excessive moisture absorption lowers usability and may result in some porosities.
(3) Excessive drying before use causes less in penetration and overheating of the electrode.
Typical Chemical Composition of Weld Metal (%):
C |
Mn |
Si |
P |
S |
0.07 |
0.41 |
0.32 |
0.012 |
0.010 |
Typical Mechanical Properties of Weld Metal:
Yield Point
N/mm2 (Kgf/mm2) |
Tensile Strength
N/mm2 (Ksi) |
Elongation
(%) |
Impact Value
Deg C, J (Deg F, Ft-lbs) |
450 (65) |
510 (74) |
27 |
0,80 (32,59) |
Size and Recommended Current Range (AC or DC +/-):
Diameter (mm) |
2.5 |
3.2 |
4.0 |
5.0 |
Length (mm) |
350 |
350 |
400 |
400 |
Ampere |
Flat |
50-90 |
70-130 |
110-170 |
160-220 |
V & OH |
40-80 |
70-110 |
90-140 |
130-180 |
Welding Positions:
ALL POSITIONS INCLUDING VERTICAL DOWN
Approvals:
ABS, BV, DNV, LRS
Packing:
20 Kg corrugated box, with 4 units of 5 Kg shrinked plastic wrapped paper boxes inside.
Special requests on packing are accepted. |
